Matrice 4T Gimbal Camera Payload Housing Replacement Guide

August 11, 2026

Matrice 4T Gimbal Camera Payload Housing Replacement Guide

The Matrice 4T gimbal camera payload uses a two-piece housing: a front faceplate and a rear enclosure back cover. These structural shells protect the internal camera modules, motors, and cables from environmental damage. After a crash or impact, the housing can crack or shatter, exposing internal components to dust, moisture, and further damage. Replacing the housing restores protection without requiring a full payload replacement.

When to Replace the Payload Housing

Visible cracks or breaks in the front faceplate or rear cover
Housing pieces loose or separated after a crash
Dust or moisture entering the payload through damaged housing
Cosmetic damage affecting resale or professional appearance
Screw bosses stripped or broken

Compatible Parts

Gimbal Camera Payload Front Faceplate Housing Shell Compatible with Matrice 4T — SKU AT00035
Gimbal Camera Payload Rear Enclosure Back Cover Compatible with Matrice 4T — SKU AT00036

Tools You'll Need

Phillips screwdriver (PH000)
Plastic pry tool
Tweezers
Replacement front faceplate and/or rear enclosure
Clean, stable workspace

Step-by-Step Housing Replacement

Step 1 — Power off and remove the battery.

Step 2 — Detach the payload from the aircraft. Release the payload locking mechanism and detach the gimbal payload. Place on a clean, padded surface.

Step 3 — Remove the damaged housing piece. Identify whether the front faceplate (AT00035) or rear enclosure (AT00036) is damaged. Remove the retaining screws from the damaged piece.

Step 4 — Carefully separate the housing. Use a plastic pry tool to gently separate the housing from the internal assembly. Do not force it — internal cables may be routed along the housing walls.

Step 5 — Disconnect any cables attached to the housing. Some cables may be clipped or routed along the inside of the housing. Disconnect them carefully before fully removing the housing piece.

Step 6 — Install the new housing piece. Position the new faceplate or rear cover over the internal assembly. Reconnect any cables that were attached to the housing.

Step 7 — Secure with screws. Tighten the retaining screws evenly. Do not overtighten — the housing is plastic and screw bosses can strip.

Step 8 — Reattach the payload and test. Reattach the payload to the aircraft. Power on and verify all cameras are active and the gimbal initializes correctly.

Tips for Enterprise Payload Repair

Replace both front and rear housing at the same time if both are damaged — mismatched housing pieces can cause fit issues
Inspect internal cables for damage while the housing is open — a crash that breaks the housing often damages cables too
After reassembly, run a full payload calibration before the next mission

Item added to your cart

Matrice 4T Gimbal Camera Payload Housing Replacement Guide